How is the 3d Filament Made?
How is the 3d printing filament made ?
1: DEHUMIDIFYING THE PLASTIC PELLETS
At the start, the polymer used for filament manufacturing is in the form of colorless plastic pellets. In this state, it’s prone to absorbing the moisture from the air. The plastic pellets are sucked into a dryer. Using a dry air aggregate with a series of dust filters, we dehumidify the pellets before sending it to the extrusion line.
2: COLOR MEASURING DYE COLORS
The final color of the filament is determined by the addition of pigment to the clear plastic granulate. During the manufacturing process, the color is being constantly measured and the pigment dosage is adjusted in real time accordingly to the metric. Should the color get out of acceptable tolerance anytime during the manufacturing, the spool is immediately discarded.
3: EXTRUSION
The granulate is melted in a sequence of heated zones with gradually increasing temperature. A screw pushes the molten plastic forward until it reaches the die head. After that, the extruded plastic immediately enters the cooling baths.
4: Cooling
Extruded filament travels through a series of cooling baths. These baths contain specially treated soft water with antibacterial and rust preventing solutions.
5: DIAMETER MEASURING
Accurate filament diameter is one of the most important characteristics of DOWELL 3D Printing filament .
Unlike the industry standard of +-0.05 mm, our tolerance limit is set to +-0.02 mm for the vast majority of materials .
6: WINDING
Every spool of Dowell is tightly wound up to ensure smooth unrolling on a spool holder.
7:Packing
Every spool is vacuum packed to prevent moisture absorption during transport. As the last step, the filament is placed in a cardboard box.
